Upgrading a Depot Repair Part

Once the outstanding ECOs have been applied against a part, the Upgrade button on the Depot Repair form is enabled. The next step is to upgrade that part. The upgrade process transacts the old part out of depot repair and replaces it with the new part revision.

When ECOs are viewed against a part request, the most recent ECO is selected by default. If the repair item has already been received, then the current location of the part is displayed. When multiple ECOs are applied against the part, each upgrade must be performed separately.

To upgrade a Deport Repair part

1. Select an ECO code.
2. If the serial number of the part changes following the upgrade, enter a new serial number.
3. Verify the correct location of the part in the Repair Unit Located At field.
4. Verify the account in the Depot Repair GL Acct field. This field is prefilled with the default depot repair expense GL account.
5. Verify the correct part status. Both sets of Part Status option buttons are preset to the current part status.
6. Select Upgrade.
7. Select Done to close the form.

Did this topic help you? Email us your feedback.
Last updated: 11/1/2007 4:39:11 PM
© by Dovetail Software, Inc.